Use only with a low speed, (200-400 rpm), hand held drill.There is no guarantee for bits broken due to excessive force.Due to the long length of some of these bits you can break them if you force them. ![]() Need it even longer?…Add one of the NW Extension Bits…up to 4′ long with 6 set screws! Originally made for Log Builders and Timber Framers…Very popular. Switch drill motor from forward to reverse a couple of times working the bit in and out to remove wood slivers on the exit side of the hole.Īll this said…these are top quality, high demand auger bits. To avoid this, do not force the bit when exiting. If this happens on any auger bit, the bit must be pulled out to allow it to clean the chip accumulation.ĭue to the large flites on the larger diameter auger bits it may tend to hook the wood slivers on the exit side of the log or timber causing it to screw it’s way on through. Smaller flites on the 7/8″ and 1″ diameters may load up as the center shaft is 1/2″, thus the 1″ bit only has 1/4″ of flites each side. pull the bit out to remove the accumulated chips. Note: Don’t expect the full length flites to continue to eject chips unless you occasionally (every few inches), “clear” the hole. (flites come to within approximately 5″ of the drill end of the bit)…thus a 40″ bit has 35″ of flite for moving chips.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |